Frage an alle. Hat jemand Erfahrungen mit den Expansions Boards X400 oder X600 für den Raspberry B+ oder v2 von Ali... oder DX... .... oder aus der Bucht, der Bezugsmöglichkeiten gibt es viele.
Habe selbst ein X400 geordert. GPIO's herausgeführt, IR Receiver, 3,5mm und RCA Audio, Audioeingang, DC Output, Amplifier 2x20Watt, Burr DAC
-----------------------------------------------------------------------------------------------------------------
Input Voltage
- 6V to 24Vdc converted to 5V, 3A via step-down DC/DC converter to power the Raspberry Pi
Audio
- Full-HD audio – up to 24-bit/192kHz playback
- Class leading audio; 112db SNR, and THD of 0.0019%
- Audiophile TI Burr Brown 32-bit/384kHz DAC (TI PCM5122)
- Uses the digital I2S audio signals to reduce CPU load over USB audio solutions
- Integrated hardware volume control
- Mute can be enabled / disabled via jumper
- Built in High quality audio headphone amplifier (TI TPA6133A)
- Earphone AMP can be enabled / disabled via jumper
- Built in High quality Class-D stereo audio amplifier (TI TPA3118D2)
- Up to 2 x 20W into 4 ohm
- AMP can be enabled / disabled via jumper
- Phono/RCA connectors
- 3.5mm stereo audio jack
- Speaker terminals
Wireless -
Built in IR sensor (38KHz)
Misc
- Power output socket
- DIP switch to remove connection from RPi’s pin header
- Directly connected on top of the Raspberry Pi using the board GPIO header pins
- No wiring nor soldering is required
- Duplicated the 40-pin header of the R-Pi in order to support existing expansion boards
- Suitable for Raspberry Pi Model B+ and Raspberry Pi 2 Model B NEW!
Dimensions: 85 x 56mm (Same size as Raspberry Pi)
paulaner